I started to build my LoopA and all look good exept in test mode.
All other tests are good, but the EN1 just goes in -1 direction not in +1 like the other Encoders.
Any ideas ? Any components I have to check soldering ?
My guess is that either the shift register pin or the pull-up resistor is not soldered here. Do you measure +5V on the encoder pins (you’ll need to turn the encoder to read all possible states)?
Soldering locations would be
RN1 pins ⅚
IC1 pins ¾
Thanks for your quick help.
I’ll check it tomorow. And I keep you posted.
I don’t see any soldering problem on RN1 and IC1 .
To be sure, I’ll use flux to clean all pads.
I’ll Keep you posted
All works good after a flux clean on RN1 et IC1.
Thanks for your help !
The LoopA is a f.Cking tools ! Thanks MidiPhy Team and all Dev.