Following / switching pages automatically

060a2dfb48017cfe

Hello all

does someone know how or if it works to switch between the pages automatically when using more than16 steps…
I have programmed a sequence with 64 steps (4 pages)
I would like to follow the pages automatically while running the sequence.

The lowest line will walk through.
But the pages above dont run synchron they are waiting on one page….

Shurely i have searched in the manual and also in the seq 4 manual but as a beginner in this i havent found a solution.

Thanks for reading! Any suggestions?

Best Regards
Marty

0fc5608d995b44ff

@MartyMcFly no problem, try the button combination “Menu” & “Exit” - it activates follow mode on both SEQ v4+ and MatriX 🙂

Best regards and have a good new year! 🙂
Peter

060a2dfb48017cfe

Hi Peter,

thank you very much for your quick answer!!!
I had searched for a long time :-)
That worked fine!
I wish you a good year too.
Stay healthy!
Looking forward to the event and to see you tomorrow.
Hope it works fine.
Best regards.
Marty