• Eurorack
  • A1 CV (unipolar) - Channel 4 no output.... (LED+CV)

Super DAC board CH4 seems to be ok (measure changing voltages)
The Octal board seems to be soldering technical OK.

So i think it has something to do with the the Transmute 8 PCB…. looks like an multilayer pcb? not easy to follow!
On the Output-header J3 (connect to the Octal board) i measure 12V on the PIN where i followed the trace back from the octal board…. (should not be 12V - it should change, have an lfo in my program…)
(12V measured with unplugged octal-bard)

i turned the trimpot, and made solder adjustments on the parts where i thougt it has something to do with CV4…

I need a shematic to go forward.

(the rest off the Eurorack-Kit is working!)

    DONE > i did not soldered 4R49…. a mistake by leaving out the BiPolar-making-Resistors - uuups…. in the meantime i started to get into the board… but now it works - so no more work on this Picture:

    Very good! Yep, it hopefully should be logically laid out!

    Best,
    Andy

      Write a Reply...