latigid on Encoder pins are connected to the through-board header J3, pins 8/9. Then through the corresponding le mec header to IC5, pins ⅚. Best, Andy
latigid on If it was related to ICs, it would be a whole “row” or column. Thus I suspect that you need to resolder the switch or the associated diode.
Jan Here we go again🙂 I’m a bit intensive care with this build…the right LED matrix stopped working. other then that the sequencer is functionning. any ideas?
latigid on Probably cabling! Right next to the cables on le MEC R is where you could also check soldering.
